XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
1 large foam seal from each side and the center foot.
Note! The foam seals and the screws must be replaced during installation. Replace the rubber seals if necessary.
Installing rails
Install:
-
the 3 rubber seals on each side
-
the 3 small foam seals on each side
-
1 large foam seal each side at the center mounting.
Note! Ensure that the foam seals are completely undamaged.
Install:
-
the center mounting but do not tighten the screw
-
the front and the rear mounting but do not tighten the screws
-
the 5 screws on each side. See Tightening torque See: Specifications.
Check that the screw threads engage.
Note! Do not over tighten. The gasket may no longer seal correctly.
Hint: Tighten the screws in two stages to prevent misalignment.
Install the 3 covers.