XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Thread the upholstery over the backrest cushion. Secure the half moon clips as the upholstery is pulled down. Use: 115 8962 CRIMP PLIERS See: Tools
and Equipment/115 8962 Crimp Pliers.
Install:
-
the Velcro seam on the reverse of the backrest cushion
-
the upholstery at the bottom edge
-
the lumbar support adjustment knob and its cover
-
the backrest adjustment knob (if applicable).
Install the head restraint. Press the head restraint down until the catches engage.
Note! Lift in the head restraint. Check that the head restraint cannot be moved upwards.
Install the front seat. See: Front seat, replacing See: Service and Repair/Removal and Replacement/Front Seat, Driver's Seat, Front Seat/Front Seat,
Replacing.
Upholstery Seat Cushion, Replacing
Upholstery seat cushion, replacing
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Preparatory work
Removing the front seat
Remove the front seat. See: Front seat, replacing See: Service and Repair/Removal and Replacement/Front Seat, Driver's Seat, Front Seat/Front Seat,
Replacing.
Removal
Removing the seat cushion upholstery
Unhook the upholstery from around the seat frame.
Lift up the upholstery.
Unclip the upholstery from the seat cushion.
Installation
Installing seat cushion upholstery
Snap the upholstery into place on the seat cushion.
Pull down the upholstery. Hook the upholstery into place around the seat frame.
Install the front seat. See: Front seat, replacing See: Service and Repair/Removal and Replacement/Front Seat, Driver's Seat, Front Seat/Front Seat,
Replacing.
Warning! If the car is equipped with an occupant weight sensors (OWS), this must always be calibrated if the upholstery has been removed or
replaced. See VIDA vehicle communication.