XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Applies to cars with pedals part number 30714010 or higher:
Caution! Remove the plastic spacer washer. Only a steel washer may be used as a spacer, this prevents abnormal wear of the primary cable.
Press the mechanical cable into place in the pedal.
Secure the mechanical cable using the retaining clip.
Apply low-temperature grease, P/N 1161427-8, to the end piece of the mechanical cable.
Install the end piece of the mechanical cable in the cable pulley in the pedal.
Installing the brake cable in the center console
Install:
-
the outer casing for the cable in the console
-
the power distributor for the front mechanical brake cable in the two rear mechanical brake cables.
Installing the parking brake pedal
Install:
-
the disengagement cable for the pedal
-
the wiring for the switch before the pedal has been turned in
-
the parking brake pedal using the 3 x M8 screws.
Installing the relay box in the passenger compartment
Install the relay box on the bracket.
Press the relay box forward so that the catches engage in the bracket and "click".
Installing the OBDII bracket
Install:
-
the OBDII bracket
-
the 2 screws.
Installing the soundproofing panel