XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Remove:
-
the cable from the cable pulley in the pedal
-
the retaining clip
-
the outer casing for the cable from the pedal using round-nose pliers.
Pull the mechanical cable backwards at the tunnel. Ensure that the clip for the outer casing at the pedal end does not catch at the heater.
Installation
Note! For tightening torques, see Specifications See: Specifications/Tightening Torque.
Installing the front brake cable
Pull the mechanical cable into the center of the tunnel above the insulation.
Note! The mechanical cable for the parking brake pedal must be installed before the power distributor at the tunnel.
Installing the mechanical cable for the parking brake pedal