XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Note! On left-hand drive vehicles, the wide edge of the spacer washer must be facing to the left in the vehicle. On right-hand drive vehicles the
wide edge must be facing to the right.
Press the cable into place in the pedal.
Secure the cable using the retaining clip.
Apply low-temperature grease, P/N 1161427-8, to the end piece of the mechanical cable.
Install the end piece of the mechanical cable in the cable pulley in the pedal.
Installing the parking brake pedal
Install:
-
the disengagement cable for the pedal
-
the cable harness for the pedal switch
-
the 3 x M8 screws for the parking brake.
Installing the brake cable in the center console
Install the rear cables in the power distributor.
Install:
-
the carpet
-
the sill molding
-
the amplifier with the 3 x M6 screws
-
the 4 screws for the seat
-
the plastic guards for the 4 screws.
Installing the soundproofing panel
Install:
-
the soundproofing panel
-
the 2 screws.
Installing the center console
Install the center console. See: Center console, replacing See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair.