XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Removal, replacement and installation -> Engine with mountings and equipment -> Engine -> Transmission ->
Remove the 7 screws holding the gear housing.
Use: Pliers, 9995670.
To remove the gear housing from the engine block pry at the lugs.
Important!
The components are machined together. If a component is damaged, both components must be replaced at the same time.
To ensure that the locking pin is removed at the same time, screw a self-tapping screw (4 mm) into the locking pin (1).
Use: Extractor, 9997315. Screw, 2 pcs, M8 x 25 (2) Use the nut (3) and carefully pull out the unit. Check that the locking pin is included.
Note:
Do not substitute tool (9997315) with any other puller or method. Any damage occurring to the sealing surface of the gear housing will result in a
leak.
Important!
Take extra care when handling this component.
Note!
Inspect the locking pin after removal. If the locking pin is broken in the engine block, the shaft has worn in its bearing position, which means that the
engine block must be scrapped.
Installation
Note!
Ensure that the contact surfaces are clean and free of foreign material.
Blind cover plug. (30731886)