XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Note!
Only finger tighten the bolts at this stage.
Note!
To ensure that there is no leakage at the screw (1) in the image, loosen the screw (1) and apply Thread sealing 1161056 to the screwed joint.
Tighten according to the order in the image.
Tightening torque:
-
Step 1: Gear housing,
10 Nm (88 inch pounds)
-
Step 2: Gear housing,
24 Nm (212 inch pounds)
Important!
The components are machined together. If a component is damaged, both components must be replaced at the same time.
Installation of the inner timing cover
To install the inner timing cover, see:
Removal, replacement and installation ->
Engine with mountings and
equipment ->
Engine ->
Transmission ->
Installation of the alternator
To install the alternator, see:
Removal, replacement and installation ->
Electrical system ->
Alternator and regulator ->
Alternator ->
Generator ->