XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Pull the cable with rubber grommet (1) away from the passenger compartment connector socket.
-
Pull the whole cable out from the hole in the cowl wall. Remove the rubber grommet from the cable. There is a new one on the routed electrical
cable.
Illustration B
-
Cut away the top of the new rubber grommet (1).
-
Guide the passenger compartment connector socket's cable in through the new rubber grommet.
-
Grease the rubber grommet with low temperature grease (part no. 1161417-9) on the side turned into the passenger compartment.
-
Adapt the cables up to the grommet. Guide the cables into the hole in the cowl wall.
-
Carefully pull the rubber grommet into position from inside the passenger compartment by pulling in the cable for the passenger compartment
connector socket.
-
Clamp in the electrical cable with the servo pipe using a tie strap (2) from the kit.
For all car models