XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Move the floor and insulating mat out of the way.
-
Scrape away any sealant from the flat surface at the lower edge of the A-post where the receiver unit for the remote start is to be located.
-
Clean the surface using isopropanol P/N 1161721. Wipe dry.
-
Press the receiver unit securely onto the panel surface, 10 mm (25/64") under the cable lead-in for the side door.
-
Locate the connector for the blower fan and disconnect the connector.
-
Connect the cable from the kit.