XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Take five double tie straps from the kit and secure them on the pipe and hose to the thermostat housing as well as the lower hose to the radiator.
-
Check that the cable does not chafe against sharp edges or moving parts in the engine compartment.
Caution! Do not clamp the cable directly to brake pipes, fuel lines, AC pipes or pipes to the power steering.
-
Take a tie strap equipped with clip and press it into the hole on the top of the left-hand bracket for the skid plate.
-
Grease in the O-ring on the connector on the cable to the front engine block heater socket, use low temperature grease P/N 1161427.
Note! Do not get any grease on the surfaces of the connector.
