XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Take the relay and the locking sleeves from the kit
-
Lubricate the O-rings on the connectors for the relay and front engine block heater socket. Use low temperature grease, (P/N 1161417-9).
Note! Do not get any grease on the contact surfaces of the connector.
-
Connect the cable (1) from the front engine block heater socket to the relay
-
Connect the wiring for the engine block heater and passenger compartment connector socket to either socket (2) or (3) on the relay.
-
Press the three locking sleeves from the kit over the cable splices.
Note! The large locking sleeve must be pressed over the connector on the cable from the front engine block heater socket.
-
Secure the power supply cable and the ground lead at one of the cables for the engine block heater/passenger compartment connector socket. Use a
tie strap (1) from the kit.