XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Hint: Use a small electrician's screwdriver to pry up the switch by the lock. Depress the switch at the rear edge. Pull straight out.
-
the 2 x screws
-
the control module.
Installation
Installing the damper motor module (DMM) for the defroster
Install:
-
the control module in position. Adjust the shaft journal so that it goes in
-
the 2 screws. Tighten alternately
-
the switch. Ensure that it is correctly positioned
-
the glove compartment. See Glove compartment, replacing See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and
Repair
-
the soundproofing panel. See Soundproofing panel, replacing See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Soundproofing Panel, Replacing.
Note! Identify the damper motor module (DMM) for the defroster. See VIDA vehicle communication.
Finishing
Testing the climate control system
Carry out a performance test on the climate control unit. See: Climate system, performance test See: Testing and Inspection/Component Tests and
General Diagnostics/Climate System, Performance Test.
R.H.D
Damper motor module (DMM) defroster, replacing
The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential
information in the illustrations is always correct.
Note! The damper motor module (DMM) for the defroster is only used in cars with electronic climate control (ECC). It is positioned on the
right-hand side of the car.
Removal
Removing the damper motor module (DMM) for the defroster