XC90 FWD L6-3.2L VIN 98 B6324S (2007)
The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential
information in the illustrations is always correct.
Removal
Removing the damper motor module (DMM) for recirculation
Remove:
-
the glove compartment. See Glove compartment, replacing See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and
Repair
-
the switch
Hint: Use a small electrician's screwdriver to pry up the switch by the lock. Depress the switch at the rear edge. Pull straight out.
-
the 2 x screws
-
the control module.
Check the functionality of the control module mechanism (1). Check that the arms for the dampers (2) are secure.
Installation
Installing the damper motor module (DMM) for recirculation
