XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Headlamp Alignment Sensor: Testing and Inspection
Calibrating the position sensor for Bi-Xenon lamps
If the rear electronic module (REM) or position sensor for the Bi-Xenon lamps is replaced, the position sensor must be calibrated.
Note! If the vehicle is equipped with Four-C, calibration must be carried out via suspension module (SUM).
-
Someone must sit in the driver's seat during calibration. The person must weigh at least 75 kg. Ensure that the vehicle is unladen and is on a flat
surface
-
Ignition on
-
Click on the VCT2000 symbol
-
Calibrate the position sensor.
Note! Diagnostic trouble code (DTC) REM-8F12 is stored when the rear electronic module (REM) is replaced by a new. After calibrating the
position sensor, erase the diagnostic trouble codes (DTCs) in the rear electronic module (REM).
Continue - DONE