Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Relays and Modules > Relays and Modules - Body and Frame > Power Seat Control Module > Component Information > Locations > Page 648

Page 1
background image

Power Seat Control Module: Service and Repair

Power seat module (PSM), replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.

Removal

Removing the power seat module (PSM)

Raise the seat to its highest position.

Lift the seat out of the vehicle. See: Front seat, replacing See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat, Driver's
Seat, Front Seat/Front Seat, Replacing.

Remove the key. The key must be removed to ensure that the ignition is not switched on by mistake.
Wait one minute before starting work.
Remove the 2 screws.
Disconnect the connector.
Remove the control module.

Installation

Installing the power seat module (PSM)

Install:

-

the control module

-

the connector

-

the 2 screws. Tighten

-

the key

-

the front seat as described in Front seat, replacing See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat, Driver's
Seat, Front Seat/Front Seat, Replacing.

Finishing

Ordering software

Relays and Modules > Relays and Modules - Body and Frame > Power Seat Control Module > Component Information > Locations > Page 648

[PREV PAGE] [NEXT PAGE]