Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Relays and Modules > Relays and Modules - Brakes and Traction Control > Electronic Brake Control Module > Component Information > Diagrams > Diagram Information and Instructions > Page 890

Page 72
background image

Use tool 951 2639 Terminal removal tool See: Tools and Equipment/951 2639 Terminal Removal Tool to remove the center cable terminals, as
illustrated.
At the same time pull the cable carefully backwards.

Release the inner housing section on the socket housing by lifting the sleeve beside the catch and pulling the housing section outwards.
Disconnect the cable terminals. Use tool 951 2812 Terminal removal tool See: Tools and Equipment/951 2812 Terminal Removal Tool or 951 2637
Terminal removal tool See: Tools and Equipment/951 2637 Terminal Removal Tool , as illustrated.
At the same time pull the cable carefully backwards.

Connector, assembling

Primary lock

Check that the cable terminal is undamaged.
Press the cable terminal into the housing.
Check that the cable terminal is properly locked by pulling carefully on the cable.

Secondary lock

Slide the receptacle housing into the connector.
Press the secondary lock into place.

Sealed Connector Type 1

Connector sealed, repair

Special tools: 951 2631 Terminal removal tool See: Tools and Equipment/951 2631 Terminal Removal Tool.

Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.

Connector, dismantling

The connector has no secondary lock.

Relays and Modules > Relays and Modules - Brakes and Traction Control > Electronic Brake Control Module > Component Information > Diagrams > Diagram Information and Instructions > Page 890

[PREV PAGE] [NEXT PAGE]