Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Relays and Modules > Relays and Modules - HVAC > Control Module HVAC > Component Information > Diagrams > Diagram Information and Instructions > Page 1073

Page 16
background image

Disconnect the cable terminal that is to be replaced. See: Connectors, repair See: Connector, Repair/Connectors, Repair.

Hint: If several cable terminals are to be replaced at the same time, spread out the splice points, as illustrated.

Cut the cable at a suitable point. Note the length of the new cable terminal cable.

Installation

Select a cable terminal with the same area as the old one.
Select a butt connector that corresponds to the cable area. The butt connector is the same color as the cable terminal cable.
Cut the new cable terminal cable to a suitable length.
Splice the cables. See: Joining the cables See: Wiring/Joining the Cables.

Finishing work

Reinstall the cable harness. If necessary use a crimping sleeve and tie straps.
Connect the battery negative lead. See: Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting

Relays and Modules > Relays and Modules - HVAC > Control Module HVAC > Component Information > Diagrams > Diagram Information and Instructions > Page 1073

[PREV PAGE] [NEXT PAGE]