Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 1716

Page 12
background image

Press the control module into place.

Install:

-

the connectors

-

the nut and screw

-

the door panel, see Replacing the front door side panel See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service
and Repair.

Ordering software

Order software for the driver door module (DDM) according to the table below.

Finishing

Initialize the window position in the communication input.

Driver Door Module (DDM), Replacing

Driver door module (DDM), replacing

Preparations

Caution! New software can only be ordered when the control module is installed in the car. VIDA reads off the new control module identity
which is required to order the correct software.

Always check that the control module and control module box connectors do not have bent or damaged terminals or sockets. This may have been the
cause of the fault.

Removing the driver door module (DDM)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 1716

[PREV PAGE] [NEXT PAGE]