Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Fuel Delivery and Air Induction > Fuel Pump Control Unit > Component Information > Locations > Page 2263

Page 1
background image

Fuel Pump Control Unit: Service and Repair

Control module fuel pump (FP), replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.

Removal

Remove:

-

the covers over the seat rails

-

screws, 4 pcs.

Lift out the seat on the right-hand side.

Fold up the carpet. Detach the sill trim panel slightly.
Carefully lift up the insulation block and place a block under the insulation block to access the module.
Disconnect the connector and remove the old module from the Velcro.
Remove the block and fold the carpet back. Press the sill trim panel into place.

Installation

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Fuel Delivery and Air Induction > Fuel Pump Control Unit > Component Information > Locations > Page 2263

[PREV PAGE] [NEXT PAGE]