Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Sensors and Switches > Sensors and Switches - Accessories and Optional Equipment > Arm/Disarm Switch, Antitheft > Component Information > Diagrams > Diagram Information and Instructions > Page 2582

Page 36
background image

Use tools 951 2636 Terminal removal tool See: Tools and Equipment/951 2636 Terminal Removal Tool or 951 2639 Terminal removal tool See: Tools
and Equipment/951 2639 Terminal Removal Tool to remove the primary lock, as illustrated.
At the same time pull the cable carefully backwards.

Connector, assembling

Note! Wheel sensor cables are twisted pair (positive and negative signal) cables for each wheel. It is important that paired cables are twinned in
the same way when they are reinstalled in the connector. The cables must be twisted approximately 3 times per 100 mm.

Primary lock

Check that the cable terminal is undamaged.
Press the cable terminal into the housing.
Check that the cable terminal is properly locked by pulling carefully on the cable.

Secondary lock

Press the secondary lock into place.

Connector Control Module for Anti-Lock Brake System Module (ABS), Repair

Connector control module for Anti-lock Brake System Module (ABS), repair

Special tools: 951 2630 Terminal removal tool See: Tools and Equipment/951 2630 Terminal Removal Tool , 951 2631 Terminal removal tool See:
Tools and Equipment/951 2631 Terminal Removal Tool.

Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.

Connector, dismantling

Secondary lock

Sensors and Switches > Sensors and Switches - Accessories and Optional Equipment > Arm/Disarm Switch, Antitheft > Component Information > Diagrams > Diagram Information and Instructions > Page 2582

[PREV PAGE] [NEXT PAGE]