Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Sensors and Switches > Sensors and Switches - Accessories and Optional Equipment > Parking Assist Distance Sensor > Component Information > Service and Repair > Back-Up (Reversing) Warning Sensor (Parking Assistance Module (PAM)), Replacing > Page 2704

Page 16
background image

-

Take the connector and loosen the lock.

-

Install the cable ends' pins in the connector acc. to:
1. 1. Blue (BL)
2. 2. Green (GN)
3. 3. Violet (VO)
4. 4. Yellow (Y)
5. 5. White (W)
6. 6. Black (SB)

-

Press back the connector's catch.

-

Take the long cable from the kit and connect it to the connector which has just been prepared.

-

Guide the cable down between the carpet and the door sill as far as possible to the floor and route it along the right-hand side of the car on to the
rear edge of the right-hand rear door's opening.

-

Route the cable by the front right-hand seat mounting on the right-hand seat in the second row of seats.

-

Pull away the mat from the front edge of the right-hand side panel in the cargo compartment.

-

Route the cable harness along the right side of the right seat's placement in the second row of seats, towards the front edge of the rear wheel
housing.

-

Route it further on the left-hand side of the seat belt's lower mounting, between the support bracket for the right-hand seat and wheel housing, and

Sensors and Switches > Sensors and Switches - Accessories and Optional Equipment > Parking Assist Distance Sensor > Component Information > Service and Repair > Back-Up (Reversing) Warning Sensor (Parking Assistance Module (PAM)), Replacing > Page 2704

[PREV PAGE] [NEXT PAGE]