XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Applies to cars with mudguards
-
Drill out the two rivets using a 6 mm (1/4")drill bit. Leave the inner rivet in place.
-
Turn the mud guard outwards/downwards.
-
Pull off the lower section of the bumper cover at the front edge so that the two hooks at the upper edge, and the hooks on the inside, release.
-
Grasp the lower edge of the upper section of the bumper cover. Pull straight out so that the three hooks release. The hooks may be hard to release,
if so, release using a weatherstrip tool.
-
Pull out the ends further until the four hooks, which are horizontally positioned at the upper edge, release.
