XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Fuel Gauge Sender: Service and Repair
Level Sensor, Fuel Tank, Right-Hand/Fuel Tank, Replacing
Level sensor, fuel tank, right-hand/fuel tank, replacing
Special tools:
999 5720 Wrench See: Tools and Equipment/999 5720 Wrench
Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.
Note! To replace the level sensor for the left-hand fuel tank, see: Level sensor fuel tank left, replacing See: Level Sensor Fuel Tank Left,
Replacing.
Preparation
Drain the fuel tank. See Fuel tank, draining See: Powertrain Management/Fuel Delivery and Air Induction/Service and Repair/Fuel Tank Draining.
Removing the fuel pump (FP)/level sensor
To remove the left-hand level sensor see: Level sensor fuel tank left, replacing See: Level Sensor Fuel Tank Left, Replacing
Secure a wire in the area of the ejector. The wire must be sufficiently long that it reaches over to the opposite side of the tank with some excess
remaining to ensure that it does not slide into the tank. The wire is needed to pull the hoses and wiring back to the left-hand side of the tank after the fuel
tank unit has been replaced.
