Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Oxygen Sensor > Component Information > Diagrams > Diagram Information and Instructions > Page 3901

Page 60
background image

remove the primary lock, as illustrated.
At the same time pull the cable carefully backwards.

Alternatively use tool 951 2852 Terminal removal tool See: Tools and Equipment/951 2852 Terminal Removal Tool as illustrated.

Note! tool 951 2852 Terminal removal tool See: Tools and Equipment/951 2852 Terminal Removal Tool can only be used for socket housings.

Connector, assembling

Primary locking

Check that the cable terminal is undamaged.
Press the cable terminal into the housing.
Check that the cable terminal is properly locked by pulling carefully on the cable.

Secondary locking

Press the secondary lock into place.

Connector Type 3

Connectors, repair

Special tools: 951 2630 Terminal removal tool See: Tools and Equipment/951 2630 Terminal Removal Tool , 951 2631 Terminal removal tool See:
Tools and Equipment/951 2631 Terminal Removal Tool.

Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.

Connector, dismantling

Secondary lock

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Oxygen Sensor > Component Information > Diagrams > Diagram Information and Instructions > Page 3901

[PREV PAGE] [NEXT PAGE]