XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Note! Turn the steering wheel until optimum access to the bolt is achieved. Lock the steering wheel and take out the ignition key, so that the
steering wheel lock is activated.
Note! On one side, measure the length of the track rod in relation to the steering gear housing. Make a note of the measurement.
Remove:
-
the bolt to the lower steering shaft joint
-
the connector to the solenoid.
Removing the track rod ends
Note! Make sure that the wheels are in the straight forward position. Lock the steering wheel by removing the ignition key. Do not turn the
front wheels so that the position of the steering gear is changed. This could damage the SRS system's contact reel.
Remove the track rod ends. Counterhold with a wrench so that the gaiter is not damaged.
Lowering the subframe at the rear edge
