XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Note! Some variation may occur. However, the essential information in the illustrations is always correct.
New design of the bushing
This replacement method applies to new designs of the bushing. The figure illustrates the new design.
See Bushing rear sub-frame, replacing See: for the replacement method for the early design.
Removal
Remove:
-
the rear wheels
-
the bracket between the filler pipe and the washer on the right-hand side
-
the screws in the bracket under the exhaust pipe.
Position a lifting table under the sub-frame.
Apply the lifting table so that the load is taken off the sub-frame screws.
Remove the 2 x rear screws.
Carefully lower the sub-frame approximately 70 mm.