XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Installing the torque converter
Lubricate the torque converter throat with ATF oil.
Note! Take care not to damage the oil pump during installation.
Make sure torque converter is as far into the transmission as possible. Check with a ruler. The distance between the cover and retaining tabs must be
approximately 14 mm.
Installing the transmission
Install the transmission according to See: Service and Repair/Removal and Replacement
Connecting Sleeve
Connecting sleeve
Note! Some variation in the illustrations may occur, but the essential information is always correct.
Removal and Installation
Remove and install connecting sleeve. Refer to: Sealing ring, connecting socket, B6324S, TF-80SC AWD See: Drive Axles, Bearings and Joints/Axle
Shaft Assembly/Service and Repair/Sealing Ring, Connecting Socket
Sealing Ring, Bevel Gear, Right
Sealing ring, bevel gear, right
Special tools:
999 5919 PULLER See: Tools and Equipment/999 5919 Puller
999 2943 See: Tools and Equipment/999 2943
999 7190 Drift See: Tools and Equipment/999 7190 Drift
999 1801 STANDARD SHAFT See: Tools and Equipment/999 1801 Standard Shaft
Removal
Removing drive shaft right-hand side
Remove the right-hand drive shaft. See: Drive shaft right, replacing, TF-80SC AWD, B6324S, TF-80SC, B6324S, TF-80SC AWD See: Drive Axles,
Bearings and Joints/Axle Shaft Assembly/Service and Repair/Drive Shaft Right, Replacing.
Removing the sealing ring