XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Note! The gear selector knob may be reused a maximum of four times
Press the gear selector knob so that it locks in the lever.
If necessary: Use a sheet plastic hammer and a shim to carefully hit the knob down on to the gear selector lever.
Pull the locking sleeve with the boot straight up so that it locks on the knob.
Check
Check that the lock function operates in its positions.
Gear Selector Lever Assembly Geartronic, Replacing
Gear selector lever assembly Geartronic, replacing
Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.
Removal
Removing centre tunnel console
See Center console, replacing See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair.
Detaching the boot and removing the gear selector knob
Detach the boot from the gear selector. Remove the gear selector knob. See Gear selector knob, Geartronic, replacing, B8444S, TF-80SC AWD,
B6324S, TF-80SC, B6324S, TF-80SC AWD See: Gear Selector Knob, Geartronic, Replacing.
Angle the top panel with the boot away from the gear selector lever.