XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Angle out the holder and the printed circuit board.
Transfer the entire holder when replacing the gear selector assembly stop.
Alternatively: Detach the printed circuit board from the 2 catches on the holder and pull the printed circuit board straight up.
Removing the boot and the switches from the gear selector assembly
Remove the wiring from the clips.
Disconnect the rear connector from the gear selector assembly.
Pull the front connector out of the gear selector assembly.
Separate the connectors.
Angle off the top panel and the boot.
Removing and transferring the boot from the top panel
