XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Constant Velocity Joint Boot: Service and Repair
Boot CV Joint Housing, Inner
Boot CV joint housing, inner
Note! Some variation in the illustrations may occur, but the essential information is always correct.
Special tools:
999 5519 Drift See: Tools and Equipment/999 5519 Drift
951 2619 Pliers See: Tools and Equipment/951 2619 Pliers
999 7161 Drift See: Tools and Equipment/999 7161 Drift
Removal
Caution! The constant velocity joint housing must not be disassembled.
Removing drive shafts
Remove drive shafts: Refer to: Drive shaft left, replacing, TF-80SC AWD, B6324S, TF-80SC, B6324S, TF-80SC AWD See: Service and Repair/Drive
Shaft Left, Replacing and: Drive shaft right, replacing, TF-80SC AWD, B6324S, TF-80SC, B6324S, TF-80SC AWD See: Service and Repair/Drive
Shaft Right, Replacing.
Removing the boot
Secure the drive shaft in a vise with soft jaws.
Remove:
-
the clamps on the boot
-
the boot.
Wipe off any grease.
Measuring the tripod for the constant velocity joint housing.
Mark up the position of the tripod in relation to the constant velocity joint housing.
Remove the constant velocity joint housing by tapping the edge by the rollers so that the rollers detach, one at a time.