XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Wiper Blade: Service and Repair
Tailgate Wiper Arm/Blade, Replacing
Tailgate wiper arm/blade, replacing
Special tools:
998 7693 Universal Separator B75 mm L80 mm See: Tools and Equipment/998 7693 Universal Separator B75 mm L80 mm
Removal
Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.
Removing tailgate wiper
-
Fold up the wiper arm
-
Turn the blade 90° towards the arm and pull off the blade.
Removing tailgate wiper arm and blade
-
Remove the cover
-
Slacken off the nut a few turns. Use puller 998 7693 UNIVERSAL SEPARATOR B75 MM L80 MM See: Tools and Equipment/998 7693
Universal Separator B75 mm L80 mm to remove the wiper arm
-
Remove the nut
-
Remove the wiper arm.
Installation
Note! For tightening torques, see Specifications. See: Specifications/Mechanical Specifications/Starting and Charging
Installing tailgate wiper arm and blade
-
Reset the motor
-
Position the arm with the nut. Adjust the arm so that the blade is in the middle of the black area on the windshield. Tighten the nut
-
Test operate and reset the wiper. The blade must come to rest in the middle of the black area on the windshield. Alternatively, if the windshield is
dry, approximately 10 mm below the upper edge of the field