Workshop Repair Manuals

Yugo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

yugo Workshop Repair Guides


Yugo L4-1300cc 1.3L (1991)

Engine, Cooling and Exhaust > Cooling System > Radiator Cooling Fan > Radiator Cooling Fan Temperature Sensor / Switch > Component Information > Testing and Inspection

Page 1
background image

Radiator Cooling Fan Temperature Sensor / Switch: Testing and Inspection

Fig. 1 Cooling Fan & Thermo Switch Installation

1.

Drain cooling system and remove thermo switch from radiator, Fig. 1.

2.

Connect suitable ohmmeter between switch terminals.

3.

Heat thermo switch in suitable solution while observing ohmmeter.

4.

Meter should indicate continuity when temperature reaches 196-200°F.

5.

Allow switch to cool while observing meter. Meter should indicate no continuity as temperature drops below 187-191°F.

6.

If switch fails to operate as outlined, sensor is defective.

Engine, Cooling and Exhaust > Cooling System > Radiator Cooling Fan > Radiator Cooling Fan Temperature Sensor / Switch > Component Information > Testing and Inspection

[PREV PAGE] [NEXT PAGE]