RDX AWD L4-2.3L Turbo (2010)
Air Bag Control Module: Service and Repair
ODS Unit Replacement
ODS Unit Replacement
Removal
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, then wait for 3 minutes
before starting work.
2. Remove the passenger's seat See: Body and Frame/Seats/Service and Repair/Front Seat Removal/Installation.
3. Pull out the seat-back cover/pad as needed See: Body and Frame/Seats/Seat Cover/Service and Repair/Front Seat-back Cover/Pad Replacement.
4. Remove the cover (A), then disconnect the OPDS sensor connectors (B), and front passenger's seat wire harness 18P connector (C) from the ODS
unit (D).
5. Remove the two bolts (E), and the ODS unit.
Installation
1. Place the ODS unit (A) on the seat-back frame. Tighten the two bolts (B), and connect the OPDS sensor connectors (C) and front passenger's seat
wire harness 18P connector (D) to the ODS unit. Reinstall the cover (E).
2. Install the seat-back cover/pad in the reverse order of removal See: Body and Frame/Seats/Seat Cover/Service and Repair/Front Seat-back
Cover/Pad Replacement.