ZDX V6-3.7L (2010)
Installation
NOTE: The IMOES unit is built into the driver's MICU which is part of the driver's under-dash fuse/relay box. Further more, vehicles with the keyless
access do the IMOES certification by communicating with the remote slot control unit. Because of this construction, the IMOES must be registered, or
the vehicle will not start.
1. Install the relays and connect the connectors to the driver's under-dash fuse/relay box, then install the driver's under-dash fuse/relay box in the
reverse order of removal.
2. Install the removed parts in the reverse order of removal.
3. Do the battery terminal reconnection procedure steps 1 to 4 See: Battery/Service and Repair/Procedures.
4. Register the immobilizer system with the HDS:
-
With keyless access system See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Testing and
Inspection/Programming and Relearning
-
Without keyless access system See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming
and Relearning
5. Do the remaining steps of battery terminal reconnection procedure See: Battery/Service and Repair/Procedures.
6. Confirm that all systems work properly.
