audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing pedal cluster / mounting bracket > < Brake pedal mounting bracket

A1

Separating and connecting brake pedal and brake servo
Separating and connecting brake pedal and brake servo
Separating
Special tools and workshop equipment required
   
t  Release tool -T 10159-
  W00-1293
–  First press brake pedal in direction of brake servo and hold.
2 - Push rod
3 - Retaining lugs
–  Insert release tool -T 10159- and pull in direction of driver's seat, while holding brake pedal firmly. (At this stage the brake pedal must not be allowed to move to the rear.) This will press the retaining lugs -3- of the mounting off the ball head of the push rod -2-.
For greater clarity, the illustration shows separation of the brake pedal from the brake servo with the pedal cluster removed.
–  Pull release tool -T 10159- and brake pedal together towards driver's seat. (This will pull the brake pedal off the ball head of the push rod).
Connecting
  N46-10186
–  Hold ball head of push rod in front of mounting and push brake pedal in direction of brake servo so that the ball head audibly locks into place.
–  Pull brake pedal briefly to ensure parts are engaged correctly.
  Caution
Make sure that the brakes work properly before the vehicle is driven on the road.
  N46-10185

Removing and installing pedal cluster / mounting bracket > < Brake pedal mounting bracket