A3 L4-2.0L Turbo (BPY) (2006)
‹› The clutch pedal remains engaged on the clutch master cylinder actuator rod.
-
Swivel clutch pedal slightly downward and remove over-center spring - 4 - from mounting bracket.
Installing
‹› Tightening specification. Refer to => [ Pedal Assembly and Clutch Master Cylinder Assembly Overview ] See: Pedal Assembly and Clutch Master
Cylinder Assembly Overview.
Install in reverse order, paying attention to the following:
‹› Replace self-locking nut.
‹› Lubricate the various bearing and contact surfaces with Grease (G 000 450 02).
-
Place over-center spring - 2 - in mounting bracket from above and hold end of spring in installation position with Assembly Tool (T10178).