A3 L4-2.0L Turbo (BPY) (2006)
Shift Cable: Removal and Replacement
Shift Cable and Selector Cable
Shift Cable and Selector Cable
Removing
-
Remove the shift mechanism. Refer to => [ Selector Mechanism ] See: Shifter M/T/Service and Repair/Selector Mechanism.
-
Bend open the tabs - arrows - of the base plate for selector mechanism with a screwdriver and remove the base plate.
-
Remove the gasket.
Vehicle through MY 2008
-
Remove the washers - 1 - and - 4 - and pull the cables off the pins.
Vehicles from MY 2008:
-
Pry the shift and selector cable off the pins.
All Vehicles
-
Remove circlips - 2 to 3 - and remove shift cable and selector cable from selector mechanism housing.
-
Release the cable retainer - A - for the selector and shift cables - B - as follows: