A3 Mk1
| Removing and installing input shaft, output shaft (pinion shaft), differential and selector forks |
| 1 - | Differential |
| q | Dismantling and assembling → Chapter |
| 2 - | Seal |
| q | 4 x |
| q | Renew |
| 3 - | Output shaft |
| q | Dismantling and assembling → Chapter |
| 4 - | Reverse shaft support |
| q | Dismantling and assembling → Item |
| 5 - | Reverse shaft |
| q | Dismantling and assembling → Chapter |
| 6 - | Input shaft |
| q | Dismantling and assembling → Chapter |
| 7 - | Reverse gear selector fork |
| q | Dismantling and assembling → Chapter |
| q | Installation position → Anchor |
| 8 - | Torx socket head bolt, 25 Nm |
| 9 - | Selector forks |
| q | Dismantling and assembling → Chapter |
| 10 - | Clutch housing |
| q | Servicing → Chapter |
| 11 - | Hexagon nut, 25 Nm + tighten 90° (1/4 turn) further |
| q | 4x for bearing mounting |
