A3 Mk1
Dismantling and assembling reverse shaft |
Special tools and workshop equipment required |
t | Press tool -VW 454- |
t | Thrust plate -VW 447 H- |
t | Press tool -VW 411- |
t | Centring mandrel -12-551- |
t | Thrust plate -VW 401- |
t | Press tool -VW 408 A- |
|
|
|
Reverse shaft - exploded view of components |
1 - | Clutch housing |
2 - | Needle bearing |
q | Pulling out → Fig. |
q | Renew after removing |
q | Pressing in → Fig. |
3 - | Reverse gear wheel |
4 - | Circlip |
q | Renew after removing |
5 - | Reverse selector gear |
q | Remove circlip before renewing |
q | Shoulder faces towards reverse gear wheel |
6 - | Reverse shaft |
q | Removing → Chapter |
7 - | Needle bearing |
q | Pressing out → Fig. |
q | Pressing in → Fig. |
8 - | Reverse shaft support |
q | Removing and installing → Chapter |
Note
|
|
Note
|
|