audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Hydraulics - exploded view of components > < Removing and installing over-centre spring

A3 Mk1

Removing and installing clutch pedal
Removing and installing clutch pedal
Special tools and workshop equipment required
   
t  Pliers -T10005-
  W00-1063
t  Torque wrench -V.A.G 1331-
Removing
–  Remove over-centre spring → Chapter.
–  Remove clutch pedal switch → Chapter „Removing and installing clutch pedal switch -F36- (square housing)“ or → Chapter „Removing and installing clutch pedal switch -F36- (round housing)“.
  W00-0427
Release master cylinder operating rod from clutch pedal as follows:
–  Pull clutch pedal slightly towards the passenger compartment.
–  Press both sides of mounting inwards using pliers -T10005--arrows-.
  N30-0280
–  Remove nut -A-.
–  Pull bolt out until the clutch pedal can be removed.
  N30-0216
Installing
Installation is carried out in reverse sequence; note the following:
l  The retaining clip -A- must be fitted on the master cylinder operating rod -B-.
–  Press clutch pedal in direction of -arrow- to engage. Ensure that pedal is correctly located.
–  Install over-centre spring → Chapter.
–  Install clutch pedal switch → Chapter „Removing and installing clutch pedal switch -F36- (square housing)“ or → Chapter „Removing and installing clutch pedal switch -F36- (round housing)“.
  V30-0419

Hydraulics - exploded view of components > < Removing and installing over-centre spring