A3 Mk1
| Exploded view III - adjusting clutch play between “K1” and “K2” |
Note| To adjust clutch play, install components without shim(s) → Item → Chapter. |
| 1 - | Reverse gear clutch “K2” |
| 2 - | Shims |
| q | Do not install when adjusting clutch play |
| q | Up to 3 shims may be fitted |
| 3 - | 1st to 3rd gear clutch “K1” |
| 4 - | O-ring |
| 5 - | 3rd and 4th gear clutch “K3” with turbine shaft |
| 6 - | Axial needle bearing with washer |
| q | Installation position: axial needle bearing must face small input shaft |
| q | Washer faces “K3” |
| 7 - | Gearbox housing |
| q | Planetary gearbox installed as far as small input shaft → Chapter |
