audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Separating engine from automatic gearbox 09A > < Separating engine from manual gearbox

A3 Mk1

Separating engine from automatic gearbox 01M
   
Separating engine from automatic gearbox 01M
Special tools and workshop equipment required
t  Lifting tackle -2024 A-
t  Workshop hoist -VAS 6100-
t  Socket (15 mm) -Matra V175-

   
Procedure
l  Engine/gearbox assembly removed and attached to engine bracket -T10012-.
–  Unplug electrical connectors on gearbox if necessary and move wiring clear.
–  Disconnect coolant hose at ATF cooler -arrow-.
  A10-1328
–  Remove plug from opening in cover plate for torque converter.
–  Unscrew 3 nuts for torque converter -arrow- using socket (15 mm) -Matra V175- (turn crankshaft 1/3 turn each time and counterhold at central bolt on vibration damper).
  A37-0201
–  Remove starter.
–  Hook lifting tackle -2024 A- onto automatic gearbox and workshop hoist -VAS 6100-.
  Note
To adjust to the centre of gravity of the assembly, the perforated rails of the support hooks must be positioned as shown.
  WARNING
The support hooks and retaining pins on the lifting tackle must be secured with locking pins -arrows-.
  A10-1329
–  Remove remaining engine/gearbox securing bolts.
–  Separate gearbox from engine.
–  Secure the torque converter in the gearbox using wire or support bridge -30-211 A- to prevent it falling out.
  A37-0214

Separating engine from automatic gearbox 09A > < Separating engine from manual gearbox