Audi Workshop Service and Repair Manuals

Note:

For repairs to the clutch:

=> 5-speed Manual Gearbox 02K; Repair group 30; Servicing clutch

• 15 Nm
• Sealing ring
• ◆ Replacing .
• ◆ Do not use oil
• Sealing flange - front
• ◆ Must be located on dowel sleeves
• ◆ Removing and installing
  .
• Not installed

• Cylinder block
• ◆ Removing and installing crankshaft=> Page 13-68
• ◆ Dismantling and assembling pistons and conrods => Page 13-78
• Sealing ring
• ◆ Replace
• Screw plug - 100 Nm
• 90 Nm + 90° (1/4 turn) further
• ◆ Replace
• Washer
• ◆ Note installation position
• Pressure plate/drive plate
• ◆ Removing and installing pressure plate => Page 13-63
• ◆ Removing and installing drive plate => Page 13-65
• ◆ Can only be installed in one position. Holes are off set

• Intermediate plate
• ◆ Must be located on dowel sleeves
• ◆ Do not damage/bend when assembling.
• ◆ attached to sealing flange => Fig.13-48
• Rear sealing flange
• ◆ With sealing ring
• ◆ Removing and installing
  .

→ Fig.1    Installing intermediate plate

• ‒ Attach intermediate plate on sealing flange and press onto dowel sleeves -arrows-.