Audi Workshop Service and Repair Manuals

•     1 -    → Subframe
•     2 -    Bracket
•     3 -    Upper transverse link
•     4 -    Connecting link
•     5 -    Nut, self-locking, 5 Nm
• Always replace after removing
•     6 -    Lower transverse link
•     7 -    Clip
•     8 -    Rivet/self-tapping screw, 9 Nm
•     9 -    Rear left vehicle level sender -G76
• Do not detach connecting link from ball end

Note:

Headlight basic setting is always to be performed:

• ◆ On removing and installing wishbone
• ◆ Following vehicle level sender installation work

Headlight basic setting

=> Electrical System, Self-diagnosis; Repair Group 01

Note:

→ For attaching linkage -Item -1- to sensor,use 9 mm open-ended wrench with dimension A = 4 mm so as not to damage seal.

• ◆ Tightening torque: 3.5 Nm

• ‒ → Attach retaining plate for connecting link at a distance X = 153 mm from inner bonded rubber bush of lower transverse link.