The function “04 - Basic setting” can be used to perform the following procedures: |
t
| Only applicable to vehicles with EDL and EDL/TCS: Bleeding brake system via “display group 001” if fluid reservoir has run dry → Chapter. This basic setting is only necessary if one or more of the chambers in the brake fluid reservoir has been completely emptied (e.g. leaks in brake system). |
t
| Only applicable to four-wheel drive vehicles: Switching off longitudinal acceleration sender -G251- via “display group 040” → Chapter (e.g. to check the brake system on test rollers). |
t
| Only applicable to four-wheel drive vehicles: Performing zero compensation of longitudinal acceleration sender -G251- via “display group 069” → Chapter (e.g. after renewing the following components: ABS with EDL control unit -J104- or longitudinal acceleration sender -G251-). |
|
|
|