Audi Workshop Service and Repair Manuals > A3 Mk1 > Running gear, Self-diagnosis | Self diagnosis, V.A.G Inspection Service | ABS, ABS/EDL and ABS/EDL/TCS ITT Mark 20 without ESP

Electrical check of ABS, ABS/EDL and ABS/EDL/TCS ITT Mark 20 without ESP > < Test table

The login procedure or coding II is required for zero compensation of several components.

Procedure

–	Connect vehicle diagnostic, testing and information system -VAS 5051 A- → Chapter and select vehicle system “03 - Brake electronics”. When doing this the ignition must be switched on.

Indicated on -VAS 5051 A-:

–	From list -1- select diagnostic function “11 - Login procedure” or “11 - Coding II”.

Indicated on -VAS 5051 A-:

1 -	Enter code word

–	Use keypad -2- to enter code “40168” and confirm entry by touching Q key.

Note

If display on -VAS 5051 A- reads “function unknown or function can not be performed at present” the login procedure or coding II were not successful. Repeat login procedure or coding II.

–	Terminate function “11 - Login procedure” or “11 - Coding II” by touching ← key.

–	Continue in function “04 - Basic setting” → Anchor.

Running gear, Self-diagnosis
Self diagnosis, V.A.G Inspection Service
ABS, ABS/EDL and ABS/EDL/TCS ITT Mark 20 without ESP
Login procedure or coding II

Electrical check of ABS, ABS/EDL and ABS/EDL/TCS ITT Mark 20 without ESP > < Test table

Audi Workshop Service and Repair Manuals

A3 Mk1

Running gear, Self-diagnosis Self diagnosis, V.A.G Inspection Service ABS, ABS/EDL and ABS/EDL/TCS ITT Mark 20 without ESP Login procedure or coding II

Running gear, Self-diagnosis Self diagnosis, V.A.G Inspection Service ABS, ABS/EDL and ABS/EDL/TCS ITT Mark 20 without ESP Login procedure or coding II

Running gear, Self-diagnosis
Self diagnosis, V.A.G Inspection Service
ABS, ABS/EDL and ABS/EDL/TCS ITT Mark 20 without ESP
Login procedure or coding II

Running gear, Self-diagnosis
Self diagnosis, V.A.G Inspection Service
ABS, ABS/EDL and ABS/EDL/TCS ITT Mark 20 without ESP
Login procedure or coding II