audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Wheel calibration after changing tyre or replacing control unit > < Calling up technical service software

A3 Mk1

Automatic checking of current parameters
Automatic checking of current parameters
Each time the main service menu is called up, a check is first made on the vehicle values on selecting the menu items “WIRING, TEST DRIVE, SYS. TEST, END”.
Indicated on display:
   
  
CHECK:
A3 - AB
TYRES:
205/60 15
 
>YES
NO		 

–  Pressing ENTER key to confirm “YES” option results in continuation of the corresponding menu item.
–  The following message appears if selection is not confirmed with ENTER key:
Indicated on display:
   
  
PERFORM
WHEEL
CALIBRATION

 
>OK 

–  Press ENTER key to confirm “OK” display and then perform wheel calibration → Chapter.
  Note!
If the parameters required for a menu item are not available, this menu item is deactivated and marked with a * symbol. In this case the cursor is positioned at the menu item which will set the missing parameters when implemented.
Indicated on display:
   
SERVICE MENU:
 
>



WHEEL CALIB.
* WIRING
* TEST DRIVE
SYS. TEST
* END		 

–  Confirm selection with ENTER key to permit implementation of wheel calibration → Chapter.
   

Wheel calibration after changing tyre or replacing control unit > < Calling up technical service software