audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing bevel box > < Overview - oil level in manual gearbox

A3 Mk2

Checking oil level in manual gearbox
Checking oil level in manual gearbox
  Note
t  The manual gearbox and bevel box have separate oil fillings.
t  Checking gear oil level in bevel box → Chapter
t  For gear oil specification, refer to → Electronic parts catalogue.
Special tools and workshop equipment required
   
t  Multi-point bit -3357-
  W00-0303
t  Used oil collection and extraction unit -V.A.G 1782-
  W00-10211
Procedure
l  Tightening torque → Chapter
–  Drive vehicle onto a four-column lifting platform or over an inspection pit (vehicle must be horizontal).
–  Remove noise insulation (centre) by releasing fasteners -1 ... 3-.
–  Place used oil collection and extraction unit -V.A.G 1782- below gearbox.
  A10-1565
–  Remove oil filler plug -arrow- in manual gearbox.
l  Specification: oil level up to bottom lip of filler hole
–  Top up gear oil if necessary.
–  Screw in plug -arrow- with new seal.
–  Tighten oil filler plug to specified torque → Fig..
–  Install noise insulation → Rep. Gr.66.
  N34-10017

Removing and installing bevel box > < Overview - oil level in manual gearbox