A3 Mk2
Note!
|
| 1 - | Selector lever handle |
| q | Removing and installing → Chapter |
| 2 - | Sleeve |
| q | Clips into selector lever handle |
| q | Prevents the selector lever handle from being pulled off |
| 3 - | Upper cover |
| q | Includes symbol insert |
| q | Clipped onto frame → Item. |
| q | With selector indicator and tiptronic gate |
| q | Removing and installing → Chapter |
| 4 - | Symbol insert |
| q | Clipped onto cover |
| 5 - | Printed circuit for cover |
| q | Removing and installing → Chapter |
| q | Can be checked in “Guided fault finding”, using vehicle diagnostic, testing and information system -VAS 5051-. |
| 6 - | Frame |
| q | With sliding cover |
| q | Removing and installing → Chapter |
| 7 - | Buffer stop for selector lever |
| q | Clipped onto selector mechanism |
| 8 - | Nut -10 Nm- |
| q | 4x |
| q | For securing selector mechanism to body |
| 9 - | Selector mechanism (shift unit) |
| q | Removing and installing → Chapter |
| q | With integrated printed circuit for selector mechanism, do not touch |
| q | With integrated tiptronic switch -F189- and selector lever lock solenoid -N110-, which can both be checked in “Guided fault finding”, using the vehicle diagnostic, testing and information system -VAS 5051-. |
| q | Renew selector mechanism → Chapter, if tiptronic switch -F189- is defective. |
| q | Renew selector mechanism → Chapter, if selector lever lock solenoid -N110- is defective. |
| 10 - | Detent spring |
| 11 - | Bolt -3.5 Nm- |
| 12 - | Detent plate |
| 13 - | Bolt -3.5 Nm- |
| q | 4x |
| q | For securing detent plate to selector mechanism |
| 14 - | Pivot pin |
| q | For securing selector lever cable to selector mechanism |
| 15 - | Locking plate |
| q | For securing selector lever cable to shift unit |
| q | Renew |
| 16 - | Cover |
| q | For selector mechanism |
| q | With attached gasket |
| 17 - | Self-locking nut, 9 Nm |
| q | For securing cover to selector mechanism |
| q | 4x |
| q | Renew |
| 18 - | Selector lever cable |
| q | Do not bend or kink |
| q | If the protective sleeve is damaged, the selector lever cable must be renewed |
| q | Checking and adjusting → Chapter |
| q | Removing and installing → Chapter |
| q | Do not lubricate cable eye and ball socket |
| 19 - | Nut -13 Nm- |
| q | For securing bracket → Item to gearbox |
| 20 - | Bracket |
| q | For selector lever cable |
| 21 - | Bolt -23 Nm- |
| q | For securing support bracket to gearbox |
| q | 2x |
| 22 - | Support bracket |
| q | For securing selector lever cable to gearbox |
