A4 Cabriolet Mk2
| Part III: Trapezium link, transverse link, track rod |
| 1 - | Trapezium link |
| q | Different versions available → Chapter |
| q | Combination of different versions on same vehicle is not permitted |
| q | Removing and installing → Chapter |
| q | Trapezium link bushes must not be renewed; renew trapezium link if bushes are damaged |
| 2 - | Eccentric bolt |
| q | Perform wheel alignment check if loosened → Chapter |
| q | Do not turn more than 90° in either direction (i.e. from minimum to maximum adjustment position) |
| 3 - | Eccentric washer |
| q | With lug on inner bore |
| 4 - | Self-locking nut |
| q | 95 Nm |
| q | Always renew |
| q | Suspension must be in unladen position when tightening bolt connections |
| 5 - | Bolt with washer |
| q | 85 Nm + 90° |
| q | Always renew |
| 6 - | Bottom spring seat |
| q | Turn end of spring against stop |
| 7 - | Coil spring |
| q | Note different running gear versions; see vehicle data sticker → Anchor |
| q | Removing and installing → Chapter |
| 8 - | Top spring seat |
| 9 - | Top spring seat |
| q | Only for heavy-duty running gear in conjunction with → Item |
| 10 - | Bolt with washer |
| q | 85 Nm + 90° |
| q | Always renew |
| 11 - | Transverse link |
| q | Removing and installing → Chapter |
| q | Renewing bush → Chapter |
| 12 - | Eccentric bolt |
| q | Perform wheel alignment check if loosened → Chapter |
| q | Do not turn more than 90° in either direction (i.e. from minimum to maximum adjustment position) |
| 13 - | Washer |
| 14 - | Self-locking nut |
| q | 85 Nm + 90° |
| q | Always renew |
| q | Suspension must be in unladen position when tightening bolt connections |
| 15 - | Track rod |
| q | Different versions available |
| q | For correct version refer to → Parts catalogue |
| q | Removing and installing → Chapter |
| q | Perform wheel alignment check after installing → Chapter |
| 16 - | Stone deflector |
| q | Different versions available |
| q | For correct version refer to → Parts catalogue |
| q | Only with heavy duty running gear |
| q | Removing and installing (old version) → Chapter |
| q | Removing and installing (new version) → Chapter and → Chapter |
| 17 - | Flange nut, self-locking |
| q | Always renew |
| q | Suspension must be in unladen position when tightening bolt connections |
| 18 - | Stone deflector for trapezium link |
| q | Only with heavy duty running gear |
| q | For correct version refer to → Parts catalogue |
| 19 - | Flange bolt |
| q | 25 Nm |
| 20 - | Bracket |
| q | For handbrake cable |
